Due to numerous requests, the development of a new project was started: a real-time memory emulator for ECUs with 16-bit flash memory, such as 28F200 / 400/800 and 29F200 / 400/800 (256-1024kB).
Assigned targets:
- Live tuning! Editing ot the MAPs/full ROM in real time mode.
- Online software support - TunerPRO RT
- Support for hardware table / map tracing (Address hit tracing)
- Work with any software through CobraRTP Utility, (read / write firmware in .bin format)
- The ability to upload and use 2 firmware (full) with subsequent switching in real time without the participation of a PC (dual mode Dual-mode)
What does it give and what is the difference from “firmware” via OBD connector (in boot mode)?
Indeed, most ECUs with this type of memory (except 28Fxxx) are easily "flashed" through the diagnostic connector (OBD), which does not require intervention in the hardware of the control unit. But, if you need not just load the finished firmware into the ECU, but adjust the ECU for an engine with a non-standard configuration?
